Zoomlion ZCC1100, Operator'S Manual, Page: 213 / 291

Operator’s Manual for Crawler Crane
Operator’s Manual for Crawler Crane
Assembly
and
Dism
antling
5-7
(3) The slewing fixing pin must be unpinned prior to operating the slewing
mechanism. Otherwise, the fixing device for slewing table may be damaged.
5.2.1.3 Unloading of basic machine (without crawler carriers)
a) After basic machine reaches the jobsite, remove related fixing devices and package. The
transport position of basic machine without crawler carriers is shown in the figure 5-4.
8'
6"
2600
Figure 5-4 Transport position of basic machine without crawler carriers
b) Swivel out folding brackets, and fix them via fixing pins.
Rotate support cylinders until they are vertical to the ground, and mount support plates.
Start the engine, establish electrical connection between auxiliary remote control box and
the junction box on the rear right side in the slewing table.
Turn on power supply and push “Counterweight lifting/undercarriage auxiliary device
selector switch” down to choose “undercarriage auxiliary device”. (See section 4.5.8 in
chapter 4.)
Extend support cylinders by operating undercarriage control levers to raise basic machine
from the loading floor. (See the figure 5-5)
After basic machine is raised enough (the maximum distance from the base plane of
undercarriage central section to the ground can reach 3'5"(1040mm)), drive low-loader out
from underneath the basic machine. (See the figure 5-6)
Unit: ft (mm)
For reference only.
Operators manual should be consulted and adhered to.