Zoomlion ZCC1100, Operator'S Manual, Page: 212 / 291

Operator’s Manual for Crawler Crane
Assembly
and
Dismantli
ng
5-6
b) Drive basic machine down off the low-loader (see the figure 5-2), or lift the basic machine
away from the lower-loader with the help of an auxiliary crane, and then drive the
low-loader away.
Figure 5-2 Unloading the basic machine
c) Operate derricking winch to raise main boom until the angle of main boom to front
horizontal line reaches about 70°.
Insert the pin spindle to fix the outer pipe and inner pipe of main boom tilting-back support.
See the figure 5-3.
d) Remove the pin spindle between A-frame rear anchoring rods and slewing table. Continue
spooling up derricking winch to erect A-frame to required position. Mount A-frame well.
Figure 5-3 Unloading the basic machine
DANGER
(1) Before transportation, retract the crawler carrier, lay down the A-frame and place
main boom pivot section flatly, and finally lock the slewing mechanism by slewing
fixing pin.
(2) When drive the basic machine off or onto the low-loader, a steel plate (with an
inclination less than or equal to 8° to the ground) should be used to connect the
low-loader to the ground. The angle of main boom pivot section should be less than
30° in order to protect crane against overturning.
For reference only.
Operators manual should be consulted and adhered to.