Zhone IMACS 8000, User Manual

Page: 719 / 788

Pin Outs C-21
Table C-13. RJ45 (NODE) Jack Signal Pinouts
The alarm interface is activated by the ACO setting. This will activate the device when a
designated alarm occurs. See chapter on Alarms to review the conditions and settings
necessary to enable this feature.
Connect pins 4 and 5 to provide an open relay contact to the external device upon occurrence
of an alarm. Or, connect pins 3 and 5 for a relay contact closure upon alarm.
Using the Control Terminal Port
The RS-232 Control Terminal Port allows you to connect the Integrated Access System to a
local VT100-compatible terminal, which you can then use to control the system. This port is
configured as a DCE interface.
Connect your local terminal to the TERM jack of the INF-E card. This is an RJ-45 jack in
compliance with EIA-561. Figure C-18 shows the pin locations on this jack, and Table C-14
lists the signal pinouts.
Figure C-18.RS232 (TERM) Local Interface Jack
Table C-14. RS232 (TERM) Jack Signal Pinouts
RJ48 Pin Designation Function
1 --- not used
2 --- not used
3 ANC Alarm on Closed Condition
4 ANO Alarm on Open Condition
5 ACOM Alarm Common Lead (Source)
6 --- not used
7 --- not used
8 GND Chassis Ground
RS232 Pin Function Direction 9-pin connector
4 Signal Ground N/A 5
5 Receive Data To local terminal 3
6 Transmit Data To access system 2
All other pins are open.
Pin 1
Pin 8