Zhone IMACS 8000, User Manual

Page: 462 / 788

14-42 Data Cards
Model No.
Running Head
HSU Card User Screens and Settings HSU Card
14.3.11.1 Example
If a specific call requires a 384kb multirate channel, and the current call profile for that port
is set to 64kb channelization can be changed directly from the keypad by typing the digits,
*06000. In this case, the escape character tells the HSU that a parameter change is coming, the
06 in the second and third position tells the HSU to change the existing value of 01 (64kb) to
06 (384kb). The 0 in the fourth position means keep the existing service type and 00 in the
fifth and sixth places means to keep the existing call type.
There is a special case that applies to basic channelization changes. If the second and third
characters of the command string are 00 (zero, zero), it tells the HSU to keep the existing
channelization for this port.
The information presented in this section is listed in the RS366 dialing matrix shown in Table
14-18.
14.3.12 Call Profile Loading
Sometimes the user may want to use a different call profile template than the one that is active
for a particular HSU port. The change can be performed through either the VT-100 interface
or the RS366 port. If the RS366 mode is chosen, the escape character, an eight (8) and three
subsequent digits will make up a command string that will designate a new call profile
template number to load into the HSU port dialing memory.
The command string for call profile loading is: [escape character] [8] [new call profile
number] [number to dial (optional)] [escape character to initiate action (optional)].
The command, *8002, tells the HSU to replace the currently active call profile (if any) with
call profile #002.
Another use of the escape character is to tell the HSU port to initiate dialing. The command,
*8002*, tells the equipment to change the active call profile template to call profile template
#002, and then dial the called number in that call profile, using all of the parameters in call
profile #002.
Other combinations of the elements of the initial RS366 command string can also be useful.
The command, *80176231574, tells the HSU to change the call profile to #017 and change the
called number to 6231574.
Call profile changes will always have eight (8) in the second position.
The information presented in this section is listed in the RS366 dialing matrix shown in Table
14-18.