Zhone IMACS 8000, User Manual

Page: 675 / 788

Reference Guide B-1
Appendix B
Error Messages
B.1 Error Messages Introduction
This appendix lists the Integrated Access System error messages. One of these messages may
appear at the bottom of the screen when you enter a command, indicating that the system did
not perform the requested action. This condition may have been caused by an operator error,
absence of a card in the system, or other condition. If an error message appears, take the
appropriate corrective action. For convenience, the system error messages are listed
alphabetically.
‘0000’ invalid for E, reverted to original.
The sequence 0000 is not a valid ABCD signaling sequence on E1 links. Choose a different
ABCD sequence for E1 signaling conversion to/from T1 format.
A name must be assigned to Circuit ID field.
You must enter a name for the circuit before attempting this operation. Go to the Circuit ID
field, type the desired name, and save it.
ADPCM card is not installed or rdnt.
An ADPCM card is not present in the system, or you chose a redundant ADPCM card for data
compression. Install an ADPCM card, or selected a non-redundant card.
Alarm Card can’t be active with dialing.
An External Alarm card cannot be used when HSU cards are programmed for ISDN dialing.
Remove this card.
All available PVCs are already taken.
The number of PVCs available on the FRAD Card Main Screen has been exceeded by the
number of PVCs assigned on the PVC Screen. Assign a number of PVCs on the PVC Screen
that is lower than the quantity chosen in the Main Screen.