Zeiss VISUREF 150, User Manual

Page: 36 / 134

Initial start-up
000000-2227-967-GA-GB-281021
30
File-based data exchange
•
Connect the device to your network. To do this, plug the network cable
( 8 , Fig. 1) into the relevant socket ( 8 , Fig. 5).
•
Switch to device settings.
•
Open the Interface/LAN/Network folder menu (see Section Interface
submenu , page 95 ).
•
Enter the required parameters (access data for file server etc.).
•
Enable the interface in the Interface/Interface enablement menu (see
Section Interface submenu , page 95 ).
•
Exit the device settings.

The SMB2 protocol is used for communication with the network
server.
Direct data transmission via network
•
Connect the device to your network. To do this, plug the network cable
( 8 , Fig. 1) into the relevant socket ( 8 , Fig. 5).
•
Switch to device settings.
•
Open the Interface/LAN/Network socket menu (see
Interface submenu , page 95 ).
•
Enter the required parameters (network address of your EMR/PMS
system, etc.).
•
Enable the interface in the
Interface/Interface enablement
menu (see
Section Interface submenu , page 95).
•
Exit the device settings.