3.2 Basic Module Connections Specifications
3-11
3
Mounting and Connections
( 2 ) Assembling the 24-VDC Power Supply Cable
A detachable connector is provided for the power supply terminals. Use AWG24 to AWG20 (0.2 mm
2
to 0.51 mm
2
)
twisted-pair cable to assemble the 24-VDC power supply cable with the following procedure.
1.
Strip approx. 6.5 mm from the end of the cable to expose the core wire.
2.
Insert the core wire.
Use the lever (provided) or a screwdriver to open the clamp as shown below, and fully insert the core wire into
the wire inlet.
3.
Fasten the clamp.
Release the lever or remove the screwdriver to fasten the clamp so that the core wire will remain securely in the
plug.
6.5 mm
Install the lever
Insert the hooked end of the
lever into the square hole on the
plug.
Press down on the lever until
the protrusion enters the hole on
top of the plug housing.
1
2
2
1
Cable
Lever
Cable
Screwdriver
Open the clamp by using the
lever
Open the clamp by using a
screwdriver
With the lever pressed down,
fully insert the core wire into the
wire inlet.
With the tip of screwdriver
inserted into the hole on top of
the plug housing, fully insert the
core wire into the wire inlet.
Plug
