Yamaha GRIZZLY 700 FI YFM7FGPW, Service Manual

Page: 392 / 485

8 - 45
CHAS
STEERING SYSTEM
f. Attach the ball joint remover/installer, new
ball joint (with rubber boot and retaining
ring)
1
, installer spacer
6
and installer
washer
2
to the steering knuckle
3
.
NOTE:
Do not tap or damage the top of the ball joint.
g. Hold the body
4
in place while turning in
the bolt
5
to install the new ball joint
1
into
the steering knuckle
3
.
h. Remove the ball joint remover/installer.
i. Install a new ball joint.
NOTE:
Always use a new ball joint set.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
5
2 1 3 4
6
3. Check:
• front wheel bearing
1
Bearings allow play in the wheel hubs or the
wheel turns roughly
→
Replace.
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Clean the outside of the steering knuckle.
b. Remove the circlip
2
.
c. Drive out the bearing.
WARNING
_
Eye protection is recommended when
using striking tools.
d. Apply lithium-soap-based grease to the
outer side of the bearing.
e. Install the new bearing.
CAUTION:
_
Do not strike the center race or balls of the
bearing. Should be made only with the
outer race.
f. Install the new circlip.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
1
2