Yamaha GRIZZLY 700 FI YFM7FGPW, Service Manual

Page: 133 / 485

3 - 52
CHK
ADJ
ADJUSTING THE SELECT LEVER CONTROL CABLE
AND SHIFT ROD
3. Adjust:
• shift control cable
• shift rod
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
Shift control cable:
a. Make sure that the select lever is in NEU-
TRAL.
b. Squeeze the brake lever 30 mm (1.18 in)
a
,
loosen the locknut
1
, and then adjust the
shift control cable
2
with the adjuster
3
so
that the select lever can be shifted to
REVERSE from NEUTRAL, and to PARK
from REVERSE.
c. Release the brake lever so that
a
is 0 mm
(0 in), and then verify that the select lever
cannot be shifted to REVERSE from NEU-
TRAL, or to PARK from REVERSE.
d. If the operation of the select lever is incor-
rect, repeat steps (a) to (c).
e. Tighten the locknut.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
a
3
1
2
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
Shift rod:
a. Make sure that the select lever and trans-
mission are in HIGH.
b. Loosen both locknuts
1
.
c. Adjust the length
a
of the shift rod to
413 mm (16.3 in).
d. Tighten the locknuts.
e. Start the engine, and then check that the
select lever can be shifted to each shift
position and that the appropriate indicator
light comes on when the lever is in each
position.
f. Adjust the shift control cable again.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
T
R
.
.
Locknut
15 Nm (1.5 m · kg, 11 ft · lb)
1
a