Yamaha FX10X 2008, Service Manual

Page: 46 / 411

2-29
INSP
ADJ
DRIVE V-BELT
2. Adjust the position of the V-belt by removing or
adding a spacer
1
on each adjusting bolt
2
.
3. Tighten:
• Secondary sheave adjusting bolt
2
V-belt position Adjustment
More than 1.5 mm
(0.06 in) above the
edge
Remove a spacer
From 1.5 mm (0.06 in)
above the edge to
–0.5 mm (–0.02 in)
below the edge
Not necessary
(It is correct.)
More than –0.5 mm
(–0.02 in) below the
edge
Add spacer
Part number Thickness
90201-061H1 0.5 mm (0.02 in)
90201-06037 1.0 mm (0.04 in)
T
R
.
.
Secondary sheave adjusting bolt:
10 Nm (1.0 m · kg, 7.2 ft · lb)
4. Inspect:
• Drive V-belt
Cracks/damage/wear
→
Replace.
Oil or grease on the V-belt
→
Check the pri-
mary and secondary sheaves.
5. Inspect:
• Primary sheave
• Secondary sheave
Oil or grease on the primary and secondary
sheaves
→
Use a rag soaked in lacquer thin-
ner or solvent to remove the oil or grease, and
then check the primary and secondary
sheaves.