Yamaha FX10X 2008, Service Manual

Page: 104 / 411

3-12
CHAS
STEERING
INSTALLATION
1. Install:
• Tie rod
1
• Locknuts 2
• Joints
3
2. Check:
• Tie rod angle
c
CAUTION:
After tightening the inside and outside ball joint
locknut
2 , make sure the tie rod 1 can be
rotated freely through the ball joint travel. If not,
loosen the locknut
2
and re-position the ball
joint so that the tie rod
1
can be rotated freely.
Tighten the locknut to specification.
È
Left side
É
Right side
3. Install:
• Tie rods
1
NOTE:
Make sure that the indentation
a
on the tie rod
faces out.
CAUTION:
Always use new cotter pins.
È
Tie rod part
number
É
Set length
a
Ê
Tie rod
length
b
8GL-23830-00
(FX10/FX10RT/
FX10RTR/
FX10RTRA)
544.0 mm
(21.42 in) 475.5 mm
(18.72 in)
8HA-23830-00
(FX10MT/
FX10MTR/
FX10MTRA) 518.0 mm
(20.39 in) 449.5 mm
(17.70 in)
Tie rod angle:
32°
T
R
.
.
Tie rod end locknut:
25 Nm (2.5 m · kg, 18 ft · lb)
LOCTITE
®
Tie rod and pivot arm nut:
35 Nm (3.5 m · kg, 25 ft · lb)
Tie rod and steering knuckle nut:
28 Nm (2.8 m · kg, 20 ft · lb)
a
3
b
2 1 2 3
C
C
È É
a
1