Yamaha FX10X 2008, Service Manual

Page: 19 / 411

2-2
INSP
ADJ
GENERAL MAINTENANCE AND LUBRICATION CHART
GENERAL MAINTENANCE AND LUBRICATION CHART
NOTE:
Brake system:
• After disassembling the master cylinder or caliper cylinder, always change the brake fluid. Regularly check
the brake fluid level and add fluid if necessary.
• Replace the oil seals of the master cylinder and caliper cylinder every two years.
• Replace the brake hose every four years, or if cracked or damaged.
ITEM REMARKS
INITIAL EVERY
1 month or
800 km
(500 mi)
(40 hr)
Seasonally
or 4000 km
(2500 mi)
(200 hr)
Engine oil • Change (warm engine before draining)
∗
Engine oil filter cartridge • Replace.
Every
20000 km
(12000 mi)
∗
Cooling system
• Check coolant level.
• Air bleed the cooling system if necessary.
∗
Primary and secondary
clutches
• Check engagement and shift speed.
• Adjust if necessary.
Whenever operating elevation
is changed.
• Inspect sheaves for wear and damage.
• Inspect weights/rollers and bushings for wear for primary.
• Inspect ramp shoes/bushings for wear for secondary.
• Replace if necessary.
• Lubricate with specified grease.
∗
Drive chain
• Check chain slack.
• Adjust if necessary.
Initial at 500 km (300 mi) and
every 800 km (500 mi) thereaf-
ter.
∗
Drive chain oil
• Check oil level.
• Change.
∗
Brake and parking brake
• Adjust free play and/or replace pads if necessary.
• Change brake fluid. See NOTE following this chart.
Control cables
• Make sure that operation is smooth.
• Lubricate if necessary.
∗
Disc brake installation
• Check for slight free play.
• Lubricate shaft with specified grease as required.
Every 1600 km (1000 mi)
∗
Slide runners
• Check for wear and damage.
• Replace if necessary.
∗
Skis and ski runners
• Check for wear and damage.
• Replace if necessary.
∗
Steering system
• Check toe-out.
• Adjust if necessary.
∗
Steering bearings
• Check bearing assemblies for looseness.
• Lubricate with specified grease.
∗
Ski and front suspension • Lubricate with specified grease.
∗
Suspension component • Lubricate with specified grease.
Fittings and fasteners
• Make sure that all nuts, bolts and screws are properly tightened.
• Tighten if necessary.
∗
Battery
• Check condition.
• Charge if necessary.
∗
It is recommended that these items be serviced by a Yamaha dealer.
2