Yamaha DVR-1000, Owner'S Manual

Page: 14 / 484

System connections
12
En
Connecting the speaker cables
– Be sure to connect the end of the supplied speaker
cable (where the red and black cable lengths differ)
to the front speaker, and leave some slack.
– Be sure to connect the red cable to the red terminal
(subwoofer and front speakers) and the black cable
to the black terminal.
1
Remove approximately 10 mm (0.4 in) of insulation
from the end of each speaker cable and then twist the
exposed wires of the cable together to prevent short
circuits.
2
Loosen the knob.
3
Insert one bare wire into the hole in the center of each
terminal.
4
Tighten the knob to secure the wire.
Connecting the subwoofer
Be sure to connect the red cable to the red terminal
(subwoofer and front speakers) and the black cable to the
black terminal.
1
Remove approximately 10 mm (0.4 in) of insulation
from the end of each speaker cable and then twist the
exposed wires of the cable together to prevent short
circuits.
2
Loosen the knob.
3
Insert one bare wire into the hole on the side of each
terminal.
4
Tighten the knob to secure the wire.
Notes
10 mm (0.4 in)
Red: positive (+)
Black: negative (–)
Note
10 mm (0.4 in)
R
L
Red: positive (+)
Black: negative (–)
R
L
R
L