- Glide → Glide settings for the sample/wave part
- Muted → Sets if the audio output of this part should be muted or not (signal can still be
used for modulations)
Clone Notes from → Selects if the notes should be cloned from the source. With this
multiple waves/samples can be sequenced from one source
Clone Coarse → If notes are cloned, this sets the note transpose/offset in semitones
Clone Fine → If notes are cloned, this sets the fine-tune for the main note.
Modulation Source → Selects if the current audio should be either FM modulated by one or
more other waves/samples or Hardsynced to another waveform
Pulsewidth (Pulse) → This determines the pulse width of the pulse wave in case that the
current waveform is set to ‘Pulse’
Wavefold → Sets the current wavefolding amount for the current sample/wave part
Bitcrush → Sets the bitcrush settings for the current sample/wave part
Distortion → Sets the distortion settings for the current sample/wave part
You can use the
UP / DOWN
button to switch between all 4 Wave/Sample settings (for both audio
tracks)
Track Setup (Midi Track)
- Track Clock → See track setup of the
→ Track Setup (CV/Gate Track).
- Transpose → Allow or avoid the transposing of the track. This is for the global and the
track transpose.
- Loc.Trigger Delay → See track setup of the CV/Gate track.
- Random FX1..3 → Enables randomized values for the selected FX. If turned on and a
range selected, all FX values in the selected FX will play with random values within the
selected ranges. This can be also enabled/disabled with the Random FX command
(RDMN) from the FX list. Press
OK
to get to the
and change
the ranges.
- Base Midi Channel → Set the Midi track to a midi channel so the generated Midi data from
that track is routed to that channel. (if not overruled otherwise)
- Overrule Column 2,3,4 → Usually all notes from the 4 midi note columns will be played on
the base midi channel. This can be overruled so the selected columns can sequence on
another channel.
NerdSEQ – a tracker based Eurorack sequencer
Page 93
User Manual Revision V1.26 for Firmware V1.26
12 July 2022
