Xinje DS5F Series, User Manual

Page: 22 / 210

20
Oil and water
solutions
When using in places where water droplets are dropping, please use it on the
basis of confirming the protection level of servo motor. (except for the
shaft-through part) When oil droplets will drip into the shaft-through part,
please specify the servo motor with oil seal.
Conditions for use of servo motors with oil seals:
◆
Make sure the oil level is below the lip of the oil seal when using.
◆
Please use the oil seal to keep the splash of oil droplets in good condition.
◆
When the servo motor is installed vertically upward, please pay attention not
to oil accumulation on the lip of the oil seal.
Stress state of cable
◆
Do not "bend" or apply "tension" to the wire, especially the core of the
signal line is 0.2mm or 0.3mm, very thin, so when wiring (using), do not make
it too tight.
Item Description
Processing of
Connector Part
For the connector part, please pay attention to the following items:
◆
When connecting the connector, please make sure that there is no foreign
matter such as garbage or metal sheets in the connector.
◆
When connecting the connector to the servo motor, it is necessary to connect
the connector from the side of the main circuit cable of the servo motor first, and
the grounding wire of the main cable must be connected reliably. If one side of
the encoder cable is connected first, the encoder may fail due to the potential
difference between PE.
◆
When wiring, please make sure that the pins are arranged correctly.
◆
Connectors are made of resin. Do not apply shock to avoid damaging the
connector.
◆
When carrying out the operation under the condition that the cable remains
connected, it is necessary to grasp the main body of the servo motor. If only the
cable is seized for handling, it may damage the connector or pull the cable off.
◆
If bending cable is used, full attention should be paid to the wiring operation
and stress should not be applied to the connector part. If the stress is applied to
the connector part, the connector may be damaged.
2.2.3 Installation environment

Do not use this product near corrosive and flammable gas environments such as hydrogen sulfide,
chlorine, ammonia, sulfur, chlorinated gas, acid, alkali, salt, etc.

In places with grinding fluid, oil mist, iron powder, cutting, etc., please choose motor with oil seal.

A place away from heat sources such as stoves;

Do not use motor in enclosed environment. Closed environment will lead to high temperature and
shorten service life of motor.