Xinje DS5F Series, User Manual

Page: 101 / 210

99
4. Output torque up to limit value signal
Parame
ter
Signal
name
Default
setting Suitable
mode
Meaning
Modify Effective
P5-42
Torque
limit
/CLT
n.0000 All
Output signal when
motor output torque up
to P3-28, P3-29.
Anytime At once
No terminals are assigned by default. The parameter range is 0000-0014, which is assigned to the
output interface through parameter P5-42. When set to 0002, the signal is output from the SO2
terminal.
5.7.3 Speed limit
Parameter Meaning
Default
setting
Unit Range Modify Effective
P3-14
Forward max speed
command limit
4000 rpm
0
～
65535
Servo bb At once
P3-15
Reverse max speed
command limit
4000 rpm
0
～
65535
Servo bb At once
Note: P3-14 and P3-15 are effective in all the modes.
5.7.4 I/O signal distribution
5.7.4.1 Input terminal distribution
1. Input signal distribution
Parameter
Parameter Meaning Set value Meaning
P5-20
～
P5-36
n. 0
Distribute input
terminal no.
0: NO signal
1: NC signal
No meaning
Basic filter time
n.0000
Not distribute to terminal input
n.000x
Input always open signal from SIx
n.0010
Set the signal to be always valid
n.001x
Input always close signal from SIx
Note: The basic filtering time refers to input terminal filtering time.
2. default setting of input terminal
Input terminal SI1 SI2 SI3 SI4
signal /S-ON /ALM-RST /P-OT /N-OT
3. Filtering time of input terminal

Related parameter
Parameter Meaning
Default
setting
Unit Range Modify Effective
P5-18
SI filtering time
multiple
1 - 0~10000 Anytime At once
SI input filtering time is determined by IO parameter value and P5-18. Examples are as follows:
Pulse deviation clear set to SI1 terminal, and 30ms Filtering Time
The parameters are set as follows:
P5-34=n. 0 3 0 1
P5-34.0
P5-34.2