![background image](http://html.mh-extra.com/html/xerox/phaser-2135/phaser-2135_advanced-features-and-troubleshooting-manual_885471141.webp)
128
Phaser Color Printer 2135
Networking
Step-by-Step Setup for IBM TCP/IP for OS/2
TCP/IP Protocol Configuration
1.
Acquire two IP addresses for use on your server and your Phaser 2135 printer.
2.
Install TCP/IP for OS/2. Remember to open LAN Adapter and Protocol Support
(LAPS/MPTS, etc.) and configure the TCP/IP protocol for your network adapter. (See
your OS/2 documentation for configuring network adapters for the TCP/IP protocol.)
3.
Open (double-click) TCP/IP Configuration Object.
■
Click the
Printing
tab and enter the following:
■
REMOTE PRINT SERVER = Printer IP Address in 32-bit dotted decimal notation
(e.g., 127.0.0.0).
■
REMOTE PRINT SERVER’S PRINTER = ps (Enter
ps
without quotes and in
lowercase.)
■
MAXIMUM NUMBER OF LPD PORTS = Enter a number between 2 and 64
inclusive.
■
FOR OS/2 PRINTING ONLY (NO WIN-OS/2) Click the
Autostart
tab. Highlight
lprportd
, then click
Autostart Service
,
Foreground Session
and
Minimized
.
■
Close the TCP/IP Configuration Windows. Click
SAVE
, then reply
YES
to Update
CONFIG.SYS.
■
Shutdown your server/workstation and reboot.
Note
Once completed and you have rebooted, use the “ping” command at an OS/2
Command Prompt to ping your server/workstation’s IP address. Repeat the ping
command using your Phaser 2135 printer’s IP Address to confirm that your
printer is configured properly for using TCP/IP.