Xerox Nuvera 100, Operator'S Manual

Page: 66 / 234

Overview
1-46 Operator Guide
• The job programmer may be able to improve the speed by
using the LCDS PDL command OUTPUT TMODE in the JSL
to run the print job in a lower pitch mode. Refer to the
OUTPUT TMODE parameter in the Xerox DocuPrint EPS
Using LCDS Print Description Language for information on
using this command.
• Similarly, if the system cycles down frequently because your
external finishing equipment has a slower throughput rate
than the printing system, the OUTPUT TMODE command
can be used to lower the pitch mode to match the speed of
the finishing equipment. This can improve overall throughput
by avoiding time-consuming cycle downs.
NOTE: Pitch mode changes are supported only for LCDS
printing.
Paper size and pitch mode minimum and maximum
The illustrations in this section show the pitch modes in which
you can operate, with the smallest and largest size papers
supported by the printing system.
Using small paper
sizes in 8 pitch
mode
Printing in 8 pitch mode provides the highest throughput speed
available (up to 206 ppm). However, keep the following in mind
when you select the paper you want to use for this mode:
• Paper sizes smaller than 8 inches / 203 mm in width are
supported only when the optional 7 inch paper kit is installed
on the printer.
• The leading edge of any paper used in the printer cannot be
less than 10 inches / 254 mm long.