CdQdec=_TU
$"
45@! C4QdQ5^dbi@Q^U\
CdU``UbCdQdec
Press
to see the status of each stepper, to turn the stepper on
or off, to advance the stepper (by changing the weld count), or to
reset the stepper.
Note:
The Stepper Status display cannot be used to program the
linear stepper profile or the SureWeld stepper parameters. To
do this, you must press the
PROGRAM MODE
key and press
for the Review Stepper menu. (For more information, see
“Review Stepper” on page 2-7.)
The information shown in the Stepper Status display is based on
the stepper used by the schedule selected for a device.
<
9>51B
C
D5@@5B
C
D1DEC
4
9C@<1I
If you defined the stepper as a linear stepper on the Review
Stepper menu described in “Review Stepper” on page 2-7, press
and you’ll see a display similar to the one on the next page.
FAULT
STATUS
Press
to see the fault information logged at the WCU,
to determine which WCU and fault condition caused the
fault or alert. (See page 4-7.)
NETWORK
STATUS
Press
to see a running count of the communication
errors between the DEP-100S and the weld control. This
display is provided to troubleshoot the MEDLAN network.
(See page 4-11.)
REVISION
STATUS
Press
and then
to display the revision level
numbers for the software used by the DEP-100S and the
weld control unit.
HARDWARE
STATUS
Press
and then
to display the software program
and hardware version numbers for the central processing
unit (CPU) and network node adaptor (NA) of a DEP-100S.