4Yc`\Qi=_TU
#&
45@! C4QdQ5^dbi@Q^U\
Note:
You must download your changes before they take effect at the
weld control.
GU\T>_GU\TCdQdec
The W/NW Status display lets you select either weld or no weld
mode for a device. This is a software setting (rather than using a
hardware No Weld switch on the weld control enclosure.)
This display enables you to select WELD MODE or NO WELD
MODE for each weld control from the DEP-100S, rather than
from the I/O.
When you press
to select this display, you’ll see a display
similar to the one below.
In the sample display shown above, the selected
G3E
is
in
G5<4=?45
• To change the weld mode, press
(TOGGLE) , and
the selection changes. (Each time you press
, the
display shows the new weld status:
G5<4=?45
or
>?
G5<4=?45
.
• To see a different weld control, press
and enter
the new WCU number and then press
-
.
• To exit the W/NW Status display, press
.
88D" 3?==?>
D_WW\UGU\T>_GU\T=_TU
=?45*G5<4=?45
G3E D?77<55H9D
6!6"6#6$
