?fUbfYUg_VdXU45@! C
!(
45@! C4QdQ5^dbi@Q^U\
The cursor shows which function is selected, but it is not under a
programmable value. To change the stepper number assigned by
this function, press the
U
key. (The cursor moves under the
value #01.)
You can now press:
•
O
and
U
move the cursor along the current line of
the display. (In the example, it will move between the
first space on the line and the stepper number.)
•
E
to move to the next function in the weld sequence.
•
W
to move to the previous function.
•
to see the same sequence for another weld
processor (wcu#)
•
to see a different weld schedule (sch#)
•
to send your changes to the weld processor
selected (the wcu # displayed)
•
to return to the Program Mode menu
When the cursor is positioned on a value, it blinks until you
either press
-
or move the cursor to another field.
The actions available are different, based on the display you’ve
selected. For example, the cursor will not move to any value
shown on a status display, because those values cannot be
changed. This manual describes each display.
C
ICD5=
C
D1DEC
<
9>5
The top line of display shows the following system status
conditions:
HHT #nnn
This message in the upper left of the
display when power is applied. This is
the HHT’s network location (address).
FAULT
This appears in the upper middle of the
display when at least one WCU detects
a condition programmed as a fault in the
set-up parameters.
ALERT
This word in the upper middle of the dis-
play indicates that at least one WCU
detected a condition programmed as an
alert in the set-up parameters.
