4Yc`\Qi=_TU
#"
45@! C4QdQ5^dbi@Q^U\
GU\T4QdQ
The Weld Data display shows the status of certain key weld
parameters. These include the schedule initiated, line voltage,
power factor and secondary current provided during the last
weld executed by the selected weld control.
The DEP-100S shows the Weld Data display after its power up
displays. However, you can request this display at any time by
pressing the
DISPLAY MODE
key and then
(to select the
WELD DATA option).)
This display shows the weld history for the selected schedule of
the selected device. You can select another schedule by pressing
.
(Remember that the * on the Weld Data display means that
there are additional options available under
).
When you press
, the last line of the display is replaced by a
prompt asking you to enter a schedule number (or 00 to select
every schedule):
Enter the schedule number you want monitored and press
-
.
This will display the weld results for one schedule. To resume
normal weld monitoring, enter schedule #00.
W/NW STATUS:
Press
to enable or disable the firing
pulses to the WCU selected. (This is a
software No Weld, rather than a hard-
wired switch on the weld control
enclosure. (See page 3-6.)
88D" 3?==?>
@bYFCUS9@6;F1D 3613D
=1H <F
1F7 3I3cSX
<?G G3E
6!6"6#6$
