30
CleanFire Owners Manual
2016
Remove the old catalyst by gently prying it out of the
heat exchanger with a screwdriver. The old seal will fall
apart when the catalyst is removed. Clean any debris out
of the bottom ash box after completing installation.
Remove all of the old seal and inspect the ceramics below
the catalyst. Replace if damaged. Install the new seal as
shown.
Maintenance
Place a new, clean catalyst in the housing as shown. Small
gaps in the seal are acceptable as the seal will expand the
first time the boiler is fired.
Do not allow any debris to
sit on the catalyst, as this can create hot spots and will
reduce the life of the catalyst.
Replace all insulation and the catalyst cover.
Make sure the turbulators are in place and close the top
door. Reconnect the draft fan wires and the chimney
coupling.
