3
CleanFire Owners Manual
2016
• The chimney height may need to be adjusted depending on the installation and local codes. Do not connect
this unit to a chimney flue serving another appliance. Follow all state/local codes.
• Never open the tube access door or lower access door during operation!
• All cover plates, enclosures and guards must be properly maintained and in place at all times except during
maintenance and servicing. Never operate any part of the system with covers, shields or panels removed.
• Anyone who is not familiar with and/or has not been trained to operate the CleanFire may not
operate the system. Only responsible adults should operate your CleanFire. If the CleanFire is not fired
properly, damage could result and the warranty may be voided.
• Never allow children to play near or tamper with the Boiler, fuels or any other part of the system.
• Always keep the area around, and in front of the system clean and free from combustible materials.
• Keep animals away from the system.
• The operation may not be continued or restarted in the event of visible damages (for example,
thermal distortion, traces of smoke or fire, mechanical damages, etc.). Any damages must be repaired.
In the event of any doubts, please contact your authorized WoodMaster dealer.
• The system must not be exposed to external mechanical stress (for example, as storage, climbing
support, brace, or similar). This also applies for single parts (doors, covers, etc.).
• Only touch the Fire Controller and door handle during the operation. Temperatures at other points
(for example, chimney, tube access box & door, water lines…) can be very high.
• The WoodMaster CleanFire must be operated exclusively according to the guidelines for planning,
assembly, regulations, statutes and product related instructions. The manufacturer is not liable for
damages and their results, if they occurred due to improper assembly, operation, application and also
inadequate maintenance and cleaning.
• Disconnect all electrical power to the CleanFire before performing any service.
• The water pump must run continuously whenever the WoodMaster CleanFire is being used.
• Do not attempt to fire the CleanFire during a power outage.
• In the event of a power outage, the air flow to the fire will be stopped and the fire will go out. When power is
restored, the CleanFire must be relit.
• Never shut power off to the CleanFire if there is a fire and fuel in the fire chamber unless
there is an emergency.
• Take the proper precautions to ensure that the modifications made to an existing heating system does not
interfere with existing safety controls.
• Never use the following: trash, plastics, gasoline, rubber, or naphtha in your WoodMaster CleanFire.
• The WoodMaster CleanFire operates as a negative pressure combustion chamber, always open the fire
chamber door with caution.
• Read and follow these directions carefully. Retain this manual for as long as you own your CleanFire.
• For either indoor or outdoor installation.
• This wood heater contains a catalytic combustor, which needs periodic inspection and replacement for proper
operation. It is against federal regulations to operate this wood heater in a manner inconsistent with operation
Safety
