128
6196-2220
+WIND – General Indications
Description:
This command is a general mechanism to send unsolicited non-standardized indications
to the application.The identified unsolicited non-standardized indications are:
• Indication of a physical change on the SIM detect pin from the connector
(meaning SIM inserted, SIM removed)
• Indication during mobile originated call setup that the calling party is ringing.
• Indication of the availability of the product to receive AT commands after boot.
For each of these indications, a “bit flow” has to be indicated.
Syntax:
AT+WIND=
<IndLevel >
Defined values:
<IndLevel>
1
(bit-0):
Hardware SIM Insert / Remove indications (Rack open/close)
or SIM presence after software reset
2
(bit-1):
Calling party alert indication
4
(bit-2):
Product is ready to process AT commands
(except phonebooks, AOC, SMS), but still in emergency mode.
8
(bit-3):
Indication that the product is ready to process all AT commands,
at the end of init or after swapping to ADN in case of FDN
configuration
16
(bit-4):
Indication that a new call identifier has been created
(after an ATD command, +CCWA indication)
32
(bit-5):
Indication that an active, held or waiting call has been released
by network or other party
64
(bit-6):
Network service available indication
128
(bit-7):
Network lost indication
256
(bit-8):
Audio ON indication
512
(bit-9):
SIM Phonebooks reload status
1024
(bit-10): Sim phonebooks checksum indication
2048
(bit-11): Interruption indication (only if FTR_INT is activated)
If <IndLevel> is equal to 0 (default value), no unsolicited “+WIND: <IndNb>” will occur.
Combination (addition of the values) is used to allow more than one
indication flow. 0 ≤ IndLevel ≤ 4095
The response is OK if the values are in the previous range.
Summary of Contents for GD-01 TCP
Page 147: ...147 6196 2220...
