129
6196-2220
The supported events are:
<event>
0:
The SIM presence pin has been detected as “SIM removed”
(depending on 0 bit flow)
1:
The SIM presence pin has been detected as “SIM inserted”
2:
Calling party is alerting
3:
Product is ready to process AT commands (except phonebooks, AOC, SMS), at
init or after AT+CFUN=1
4:
Product is ready to process all AT commands, end of phonebook init
or swap (FDN to ADN)
5:
Call <idx> has been created (after ATD or +CCWA...)
6:
Call <idx> has been released, after a NO CARRIER, a +CSSU: 5 indication,
or after the release of a call waiting
7:
The network service is available for an emergency call.
8:
The network is lost.
9:
Audio ON.
10:
Show reload status of each SIM phonebook after init phase
(after Power-ON or SIM insertion).
11:
Show the checksum of Sim phonebooks after loading them
12:
An interruption has occurred
The AT+WIND? command is supported and indicates the <allowed bit flows>.
AT+WIND settings are automatically stored in non volatile memory (EEPROM).
This means the &W command does not need to be used and the selected flows are
always activated after boot. Default value is 0: no flow activated, no indication.
AT+WIND=? gives the possible value range (0-1023)
The unsolicited response will then be:
+WIND: <event> [ ,<idx> ]
<idx>
Call identifier, defined in +CLCC command.
Or for event 10:
+WIND: <event>,<phonebook>,<status>,...,<phonebook>,<status>
<phonebook>
SIM phonebook (“SM”, “FD”, “ON”, “SN”, “EN”)
Summary of Contents for GD-01 TCP
Page 147: ...147 6196 2220...
