Running-in programme
03.9
Maintenance of turning device
The turning device needs no other maintenance than change of
the gear box lubricating oil and regreasing of the drive shaft.
Change the lubricating oil once during the first year of operation.
After that, the oil should be changed according to chapter 04.
Regrease the drive shaft according to chapter 04.
The list of lubricating oils for the engine turning device approved
by the turning device manufacturer can be found in the end of
chapter 02.
Check also that the vent hole (3), Fig 03-1 is open.
1 Drain old oil,
preferably when warm, through the drain hole
(4).
2 Rinse the gear box
with clean, thinly fluid oil.
3 Fill the gear box with oil
(according to the table in section
01.1) through the filling hole (5) until the oil level reaches the
level gauge glass (6). Utmost cleanliness should be observed.
4 Close the oil holes
and drive the turning device a few
revolutions.
5 Check the oil level
and fill, if necessary.
1
2
3
4
5
6
7 h
0
10
20
30
40
50
60
70
80
90
100
Engine
load %
Operating hours
After change of piston rings, pistons or cylinder liners,
after honing cylinder liners
Stop. Check big end bearing temperatures
End of running-in programme. Engine may be put on normal mode
1
2
1
2
Fig 03-3
4003029701
32-200402-04
Start, Stop and Operation
03
WÄRTSILÄ 32
03 - 11
Summary of Contents for VASA 6L32
