03.2
Start
1. Remote start
2. Local start
3. Emergency start (solenoid valve)
4. Emergency start (starting valve)
Before starting the engine, check that:
•
the lubricating oil level is correct
•
the fuel system is in running order (correct preheating,
correct pressure, sufficient precirculation to heat the fuel
injection pumps)
•
both cooling water system circuits, LT and HT water circuit,
are in running order (correct pressures, circulating water
preheated and pre-circulated sufficiently to heat the engine)
•
the oil level in the governor is correct
•
the starting air pressure exceeds 15 bar
•
the starting air system is drained of condensate
•
the drain pipe of the air cooler casing is open, no leakage
•
stop lever is in work position
•
prelubricating oil pump is running and pressure is over
0.3 bar
•
turning device is disengaged
•
indicator valves are closed
•
that the automation system indicates ready for start.
All covers and protecting shields are to be mounted and closed
before starting the engine. Covers should be removed or opened
occasionally only for measurements and checks, and they must
be immediately mounted again.
Note!
Never leave the engine running when covers are removed.
03
Start, Stop and Operation
32-200402-04
03 - 2
WÄRTSILÄ 32
Summary of Contents for PAAE051728
