03.2.1 Local start
1 Start the prelubricating oil pump
to obtain a lubricating
oil pressure, over 0.3 bar.
2 Open the valve in the starting air supply system
and
drain condensate via the blow-off valve. Close the blow-off
valve when there is no more condensate.
3 Turn the crankshaft either two revolutions
by using the
turning device or run the engine on starting air for some revo-
lutions by pressing the button on the solenoid valve and keep-
ing the stop lever in stop position (red ball knob) and the
indicator valves open. In doing so the risk of water locks is
eliminated. After blowing, close the indicator valves.
4 Disengage the turning gear
from the flywheel (yellow
ball kob).
5 Check start blocking on the LDU.
Remove blockings and
return to the main page.
6 Check that the automation system
indicates ready for
start.
7 Check that the stop lever is in work position.
8 Local/Remote switch in local position.
9 Push the start button.
If the engine does not start after
starting sequence, the reason should be checked.
10 Check that the automation system
indicates that the
engine is running and that the running parameters are nor-
mal.
Note!
The starting air supply should be open when the engine is
running, otherwise the pneumatic stop may not work.
03.2.2 Remote and automatic start
See installation specific instructions.
03.2.3 Emergency start
Emergency situation engine can also be start manually by push-
ing the button on the starting solenoid or main starting valve.
32-200402-04
Start, Stop and Operation
03
WÄRTSILÄ 32
03 - 3
Summary of Contents for PAAE051728
