WÄRTSILÄ PAAE051728, Instruction Manual

Page: 307 / 394

10 Oil the collar and press the bearing in by its inner ring
with a suitable pipe. See Fig 19-3A.
11 Turn the shaft according to Fig 19-3B.
12 Oil the collar and press the bearing in by its inner ring
with a suitable pipe. See Fig 19-3B.
13 Turn the housing according to Fig 19-3C and oil the outer
surfaces of the bearings. Press the shaft into the housing by
both the inner and outer ring of the bearing with a suitable
pipe.
Mounting of bearings
14 Fit the bearing retainer (11) and tighten the screws.
15 Before re-installing the gear wheel, all contact surfaces
should be cleaned and oiled.
16 Re-install the gear wheel and the conical ring elements
(13).
Re-install the conical ring elements exactly as situated in Fig
19-4. The conical ring elements should fall easily in place and
must not jam.
17 Re-install the pressure plate (15).
18 Tighten the screws a little and check that the gear wheel
is in the right position.
Pipe 1 Pipe 2 Pipe 3
Pipe 2 Pipe 1
F
F
F
A B C
Fig 19-3
3219568935
32-200050 Cooling Water System 19
WÄRTSILÄ 32 19 - 7