Author: JJ Contributors: RR,CT Date:1/30/13 Revised:1/21/2022
Phone: 800.526.4041
Fax: 818.764.6061
Replacing and Installing a New Elevation Motor
Repair Instructions
Elite Models that Apply: EL04-EL05LE
Step
Description
Tools
Picture
1
Removing The Case
Step 1.)
Unscrew the (6) Phillips-head screws along the
bottom of the red case where it attaches to the chassis
of the machine. (2-front, 2-rear, one on each side)
Step 2.)
Lift the red case off the chassis and set it
aside.
Phillips Screw
Driver
Case Screws (Front & Rear)
Case Screws (Side)
Case Removed
2
Removing The Yoke Assembly
Step 1.)
Take off your server wheels by unscrewing the
set screw, and sliding the wheels off of the server motor
shafts.
Step 2.)
With the front end of the machine facing you
(the pointer closest to you, and the handle furthest from
you), remove both of the server wheels.
Step 3.)
Passing through the center of the Yoke and
the davit assembly is the Yoke Bolt. (This bolt has a nut
holding it on the end of the Davit Right). Using a
Crescent Wrench and a 9/16” Wrench, unscrew and
remove the Yoke Bolt, the Small and Larger Spacer, and
the 3 to 5 washers. *(
Carefully set these in separate
safe location for later use.
)*
Step 4.)
Cut all the zip ties holding the wires together
1/8” Allen
Crescent
Wrench
9/16” Wrench
The Server wheels.
The Yoke Bolt being removed.
