Wacker Neuson G 230, Operator'S Manual, Page: 64 / 254

wc_tx003618gb_FM10.fm
64
Mobile Generator
Operation (Basler Controller)
7.10 Starting and Running the Generator
Preliminary Perform the procedure below to start and run the machine.
1. Set the engine start switch (a) to the OFF position.
Note: Graphic is representative only. Your machine may vary.
2. Set the main circuit breaker (b) to OFF.
3. Set the convenience receptacle circuit breakers (c, d) to OFF.
4. Turn off all loads.
5. Check position of the voltage selector switch (e) and make sure it is set for the
desired voltage output. Lock the voltage selector switch in place if desired.
6. If equipped, set the idle switch (g) to the low speed position (turtle).
This procedure continues on the next page.
CAUTION
Possibility of injury or equipment damage. Failure to match phase, voltage, and
frequency may cause equipment connected to the generator to operate incorrectly.
►
When using the generator as a stand-by or substitute power supply, make sure
the phase, voltage, and frequency of the generator matches that of the utility
lines or of any other power source normally used.
wc_gr011540
A Ø HZ V
R
Basler
DIAGNOSTICS
DIAGNOSEN
DIAGNOSTICOS
DIAGNOSTICS
AUS AUS
APAGADO APAGADO
ARRET ARRET
OFF OFF
REMOTE START REMOTE START
FERNSTART FERNSTART
ARRANQUE REMOTO ARRANQUE REMOTO
DEMARRAGE A DEMARRAGE A
DISTANCE DISTANCE
START / LAUFEN START / LAUFEN
ARRANQUE / MARCHA ARRANQUE / MARCHA
DEMARRER / MARCHE DEMARRER / MARCHE
START / RUN START / RUN
AU AUS S
APAGAD APAGADO O
ARRE ARRET T
OF OFFF
REMOTE STAR REMOTE START T
FERNSTAR FERNSTART T
ARRANQUE REMOT ARRANQUE REMOTO O
DEMARRAGE A DEMARRAGE A
DISTANC DISTANCE E
START / LAUFE START / LAUFEN N
ARRANQUE / MARCH ARRANQUE / MARCHA A
DEMARRER / MARCH DEMARRER / MARCHE E
START / RU START / RUN N
d
c
e
b
a
f
g