Wacker Neuson G 230, Operator'S Manual, Page: 56 / 254

wc_tx003618gb_FM10.fm
56
Mobile Generator
Operation (Basler Controller)
7.3 Genset Pre-Alarms and Alarms (Shut-Down Conditions)
Background The genset controller monitors variables of engine and machine function. The
genset controller is programmed to signal pre-alarm conditions, and to shut down
the machine when an alarm condition exists.
Pre-alarms Pre-alarm conditions are:
■
Low fuel level
■
High coolant temperature
■
Low oil pressure
■
Time to maintenance
During a pre-alarm condition, the LCD panel (a) displays the type of pre-alarm, and
the LED (b) flashes. The machine is not shut down.
Alarms/
shutdowns Shut-down conditions are:
■
Low fuel level
■
High coolant temperature
■
Low oil pressure
■
Overspeed/Underspeed
■
Overcrank
■
Low coolant level (if equipped)
■
Overcurrent
During an alarm condition, the LCD panel (a) displays the type of alarm, the LED
(b) illuminates continuously, and the machine is shut down.
A Ø HZ V
DIAGNOSTICS
DIAGNOSEN
DIAGNOSTICOS
DIAGNOSTICS
R
Basler
AUS AUS
APAGADO APAGADO
ARRET ARRET
OFF OFF
REMOTE START REMOTE START
FERNSTART FERNSTART
ARRANQUE REMOTO ARRANQUE REMOTO
DEMARRAGE A DEMARRAGE A
DISTANCE DISTANCE
START / LAUFEN START / LAUFEN
ARRANQUE / MARCHA ARRANQUE / MARCHA
DEMARRER / MARCHE
DEMARRER / MARCHE
START / RUN START / RUN
E
M
E R GE NC
Y
S T O P
A Ø HZ V
R Basler
DIAGNOSTICS DIAGNOSEN
DIAGNOSTICOS
DIAGNOSTICS
042563
wc_gr010359
b
a
Variable Normal Pre-Alarm Alarm To Reset
Fuel level >15% 15% 5% Fill fuel tank. Toggle start switch.
Coolant temp 85°C±8 105°C 115°C Add coolant. Toggle start switch.
Oil pressure 60–80 psi 20 psi 15 psi Add engine oil. Toggle start switch.
Overspeed 60 Hz — 66 Hz Toggle start switch.
Underspeed 60 Hz — 54 Hz Toggle start switch.
Overcrank — — After 3 attempts Toggle start switch.
Time to maintain 250 hours 0 hours — Reset genset controller.
Coolant level Above sender — Below sender Add coolant. Toggle start switch.