Wacker Neuson G 230, Operator'S Manual, Page: 106 / 254

wc_tx003619gb_FM10.fm
106
Mobile Generator
Operation (Deep Sea Controller)
9.6 Before Starting the Machine
Before putting the generator into service, perform each item on the following
checklist.
Exterior
checks

Check for damage that may have occurred during towing or travel to the jobsite.
Repair any damage.

Make sure that the generator is level.

Chock the trailer wheels.
Internal
checks

Check engine oil, coolant, and fuel levels—fill as required.

Check the fan belt and hoses on the engine for loose connections or fraying—
tighten or replace belts and hoses as required.

Remove any debris that has lodged in vents, near the radiator, or around the
fan.

Make sure the exhaust compartment is clean, with nothing touching the muffler
or exhaust pipes.
Pre-operation
checks

Read and understand the engine owner’s manual.

Check local regulations and NEC standards for electrical connections.

Determine voltage needs; obtain proper cable and equipment to meet the
needs. Follow local regulations and NEC standards.

Make sure that the generator is grounded to a good earthen ground per local
regulations and NEC standards.

Review and follow the safety instructions found in the front of this Operator’s
Manual.
WARNING
Personal injury hazard. Failure to follow the listed procedures may cause injury to
personnel or damage to the generator.
►
Make sure that all persons setting up the generator are certified or fully trained
on the installation of the generator.