Wacker Neuson G 230, Operator'S Manual, Page: 51 / 254

wc_tx003572gb_FM10.fm
51
Mobile Generator Machine Setup
5.6 Refueling the Machine (Deep Sea Controller)
Requirements
■
Engine stopped
■
Machine/fuel tank level with the ground
■
Remote switch disconnected from the remote run terminal
■
Fresh, clean fuel supply
Procedure Perform the procedure below to refuel the machine.
1. Remove the fuel cap.
2. Place the genset controller power switch in the ON position and wait for the
Deep Sea controller to boot up.
3. Press the right arrow key to navigate to the “Engine” screen.
4. Use the up or down arrow key to navigate to the “Engine Fuel Level” screen.
The fuel level (in percentage of the fuel tank capacity) will be displayed.
Note: The “Engine Fuel Level” screen will revert back to status screen after three
minutes of inactivity.
5. Fill the fuel tank until the fuel level reaches 100%.
6. Re-install the fuel cap.
7. Place the genset controller power switch in the OFF position.
WARNING
Fire hazard. Fuel and its vapors are extremely flammable. Burning fuel can cause
severe burns.
►
Keep all sources of ignition away from the machine while refueling.
►
Refuel only when the machine is outdoors.
►
Clean up spilled fuel immediately.
wc_gr011443
 
o o
AUTO AUTO
DEEP SEA ELECTRONICS DEEP SEA ELECTRONICS
DSE 7310 DSE 7310 DSE DSE
Open Open
Close Close
Gen-Set Gen-Set
Open Open
Close Close
Load Load
Start Start Lamp Test Lamp Test
Horn Reset Horn Reset
Auto Auto
Mode Mode
Manual Manual
Mode Mode
Stop/Reset Stop/Reset
Generator Available Generator A vailab le
L-N L-N
L-L L-L
0 kW 0 kW
0 V 0 V 0.0 H z 0.0 Hz
--- pf -- - pf
0 V 0 V 0 A 0 A
DSE
DEEP SEA ELECTRONICS
DSE 7310
STOP
STOP
CAUTION
Fire and health hazard. Fuel expands when heated. Expanding fuel in an over-filled
tank can lead to spills and leaks.
►
Do not overfill the fuel tank.