Transcendent NVR Series
73
10.3.2 Edit Permission Group
Go to “Edit Permission Group” interface and then click
in the group list to edit the
permission group (the operations of the “Edit Permission Group” are similar to that of the “Add
Permission Group”, please see 10.3.1 Add Permission Group for details). Click
to save
the group as another group. Click
to delete the permission group. The three default
permission groups (“Administrator”, “Advanced” and “Ordinary”) cannot be deleted.
10.4 Black and White List
�
Click Start
à
Settings
à
Account and Authority
à
Security to go to the following interface.
�
Check “Enable” and then choose “Enable Allow List” or “Enable Block List” (the PC
client of which the IP address is in the allow list can access NVR remotely while the PC client
in the block list cannot).
�
Add IP/IP segment/MAC. Click “Add IP” or “Add MAC” button and then check “Enable”
in the popup window (only if you check it can the IP/IP segment/MAC you add be effective).
Enter the IP/IP segment/MAC and then click “OK” button. In the above interface, click
to edit IP/IP segment/MAC, click
to delete it. Click “Apply” to save the settings.
11
Device Management
11.1 Network Configuration
11.1.1 TCP/IPv4 Configuration
Ø
IP Address Settings
Click Start
à
Settings
à
Network
à
TCP/IPv4 to go to the following interface. Check “Obtain an
IP address automatically” and “Obtain DNS automatically” to get the IP address and DNS
automatically, or manually input IP address, subnet mask, gateway, preferred DNS and
alternate DNS. Click “Apply” to save the settings.
Transcendent NVR Series
74
Internal Ethernet Port Introduction:
If you use the NVR with the PoE network ports, the online state of the internal Ethernet port
will be shown on the interface. Refer to the picture below.
The internal Ethernet port is the port which connects all the PoE ports with the NVR system.
The PoE ports are available if the internal Ethernet port is online; if it is offline, all the PoE
ports will be unavailable. The IP address and subnet mask of the internal Ethernet port can be
changed to make the port in the same network segment with the IP cameras which directly
connect to the PoE ports of the NVR (it is not recommended to change the IP address and
subnet mask of the internal Ethernet port).
