Transcendent NVR Series
21
Click
to edit the found IP camera as shown on the below left. Input the new IP address,
subnet mask, gateway, username and the password of the camera. Click “OK” to save the
settings.
Click
to edit the added camera as shown on the above right. Input the new camera name,
IP address, port, username and the password of the camera. You can click “Test” to test the
effectiveness of the input information. Click “OK” to save the settings. You can change the IP
camera name only when the added camera is online. Click “Next” to continue.
�
Disk Settings.
You can view the disk number, disk capacity of the NVR and serial number,
Transcendent NVR Series
22
R&W status of the disk. Click “Formatting” to format the disk. Click “Next” to continue.
�
Record Settings
. Two record modes are available: auto and manual.
Auto
: Select one auto mode in the interface as shown below and then click “OK” button to save
the settings. See 7.1.1 Mode Configuration for details.
Manual
: Set the “Sensor Record”, “Motion Record” and “Schedule Record” of each camera.
Click “OK” to save the settings. See 7.1.1 Mode Configuration for details.