Transcendent NVR Series
35
Ø
Add Scheme
Click
in area � to create a new scheme. Click
on the top right corner of the
scheme to delete it.
Ø
Configure Scheme
a)
Select a scheme in area � and then click the screen mode button on the tool bar to set the
screen mode of the scheme.
b)
Select a camera window in area � and then double click the camera or group in area �.
The camera or group will be added into the selected window. One camera in the same scheme
cannot repeat. You can click the right-click menu “Clear” in area � to remove a single camera
or click
to remove all the cameras.
c)
Click “Apply” to save the settings.
Ø
Start Sequence View
Go to live preview interface and then click
to pop up a window. Set the dwell time in the
window and then click
to start scheme view in sequence. Double click the sequence view
interface to pause the view; double click again to restore the view. Click
to stop the
view.
5.3 Preview Image Configuration
5.3.1 OSD Settings
Click Start
à
Settings
à
Camera
à
Image
à
OSD Settings to go to the interface as shown below.
Select the camera, input the camera name (or double click the camera name in the camera list
to change the camera name), enable or disable the name and time OSD (if enabled, drag the red
name and time OSD directly in the image view area to change the OSDs’ display position) and
Transcendent NVR Series
36
select the date and time formats. Click “Apply” to save the settings.
5.3.2 Image Settings
Click Start
à
Settings
à
Camera
à
Image
à
Image Settings to go to the following interface.
Select the camera and then set the brightness, contrast, saturation and hue of the camera. You
can click “Default” button to restore the image settings to the default factory settings.
5.3.3 Mask Settings
Some areas of the image can be masked for privacy. Up to four mask areas can be set for each
camera. Click Start
à
Settings
à
Camera
à
Image
à
Mask Settings to go to the interface as
shown below. Select the camera and enable the mask. Click “Draw” button and then drag the
mouse on the image area to set the mask area; click “Delete” button to delete the mask areas;
click “Apply” to save the settings.
