Transcendent NVR Series
43
Ø
Add preset
Select camera and then click “Add” button to add preset; or click
in the camera list on
the right side of the interface to display the preset information of the dome and then click
to add preset. The operations of the “Add Preset” window are similar to that of the
PTZ control interface; please see 6.1 PTZ Control Interface Introduction for details.
Ø
Edit preset
Select camera and preset. You can input the new name of the preset and then click
to
save the new preset name. Adjust the rotating speed, position, zoom, focus and iris of the preset
and then click “Save Position” to save the preset.
Ø
Delete Preset
Select camera and preset and then click “Delete” to delete the preset.
6.3 Cruise Setting
Click Start
à
Settings
à
Camera
à
PTZ
à
Cruise to go to the interface as shown below.
Transcendent NVR Series
44
Ø
Add Cruise
Click
in the camera list on the right side of the interface to display the cruise information
of the dome and then click
to add cruise. The operations of the “Add Cruise”
window are similar to that of the PTZ control interface; please see 6.1 PTZ Control Interface
Introduction for details.
Ø
Edit Cruise
Select the camera and cruise in the “Cruise” interface. Input the new cruise name and then click
to save the cruise name. Click “Add Preset” to add preset to the cruise. Click
to
delete the preset from the cruise. Click one preset in the preset list and then click
to
move down the preset and click
to move up the preset. Click
to start the cruise and
click
to stop it.
Ø
Delete Cruise
Click
in the camera list on the right side of the interface to display the cruise information
of the dome and then click
on the top right corner of the cruise to delete the cruise.
7
Record & Disk Management
7.1 Record Configuration
7.1.1 Mode Configuration
Please format the HDDs before recording (refer to 7.5 Disk Management for details). Click
Start
à
Settings
à
Record
à
Mode Settings to go to the mode settings interface. You can set the
record time under the “Manual Record Settings” and then click “Apply” button to save the
