Transcendent NVR Series
13
The alarm input is an open/closed relay. If the input is not an open/closed relay, please refer to
the following connection diagram:
Alarm Output:
The way to connect alarm output device:
Pull out the green terminal blocks and loosen the screws in the alarm-out port. Then insert the
signal wires of the alarm output devices into the port of NO and COM separately. Finally,
tighten the screws. Provided that the external alarm output devices need power supply, you can
connect the power supply as per the following figures.
l
RS485 Connection
There are two types of RS485 interfaces:
︵
Type 1
︶
︵
Type 2
︶
Type 1: The P/Z interfaces are unavailable temporarily. K/B interfaces are used to connect
keyboard.
Type 2: The RS485 interfaces are used to connect keyboard. A is TX+; B is TX-.
2
Basic Operation Guide
2.1 Startup & Shutdown
Please make sure all the connections are done properly before you power on the unit. Proper
startup and shutdown are crucial to expending the life of your device.
Transcendent NVR Series
14
2.1.1 Startup
�
Connect the output display device to the VGA/HDMI interface of the NVR.
�
Connect the mouse and power. The device will boot and the power LED will turn blue.
�
A WIZARD window will pop up (you should select the display language the first time you
use the NVR). Refer to 3.1 Startup Wizard for details.
2.1.2 Shutdown
You can power off the device by using remote control or mouse.
By remote controller:
�
Press Power button. This will take you to a shutdown window. The unit will power off
by clicking “OK” button.
�
Disconnect the power.
By mouse:
�
Click Start
à
Shutdown to pop up the Shutdown window. Select “Shutdown” in the
window. The unit will power off by clicking “OK” button.
�
Disconnect the power.
2.2 Remote Control
�
Two AAA size batteries.
�
Open the battery cover of the remote control.
�
Place batteries. Please observe the polarity (+ and -).
�
Replace the battery cover.
Key points to check in case the remote doesn’t work.
1. Check batteries polarity.
2. Check the remaining charge in the batteries.
3. Check IR controller sensor for any blockage.
Button
Function
Power Button
Switch off—to stop the device
Record Button
To start recording
-/-- /0-9
Input number or choose camera
Fn1 Button
Future Use
Multi Button
To choose multi screen display mode
Next Button
To switch the live image
