Transcendent NVR Series
45
settings. There are two record modes: auto mode and manual mode.
Ø
Auto Mode
Motion Record
: System will record on Motion activity only.
Sensor Record
:
System will record on Alarm Sensor trigger only.
Motion Sensor Record
:
System will record on either Motion activity or Alarm Sensor
trigger or both.
Always(24
ⅹ
7) Motion Record
:
System records all the time and on Motion activity
Always(24
ⅹ
7) Sensor Record
: System records all the time and on Alarm Sensor
trigger
Always(24
ⅹ
7) Motion Sensor Record
:
System records all the time and on
Motion activity and/or Alarm Sensor trigger.
Select one Auto mode to pop up the corresponding window. Set the video encode, resolution,
FPS, bitrate and audio of each camera and then click “OK” to save the settings.
Video Encode
: the available options will be H.265 and H.264 if the connected IP camera
Transcendent NVR Series
46
supports H.265, or the option will be H.264 only.
Resolution
: the higher the resolution is, the clearer the image is.
FPS
: the higher the frame rate is, the more fluid the video is. However, more storage room will
be taken up.
Bitrate
: the higher the image quality you choose, the more bit rate will be required.
Ø
Manual Mode
If the manual mode is selected, you need to set the encode parameters and record schedules of
each camera. See 7.2 Encode Parameters Setting and 7.3 Schedule Setting for details.
7.1.2 Advanced Configuration
Click Start
à
Settings
à
Record
à
Advanced to go to the following interface. Enable or disable
cycle record (cycle record: the earliest recorded data will be replaced by the latest when the
disks are full). Set the pre-alarm record time, post-alarm record time and expiration time of
each camera and then click “Apply” to save the settings.
Pre-alarm Record Time
: set the time to record before the actual recording begins.
Post-alarm Record Time
: set the time to record after the actual recording is finished.
Expiration Time
: set the expiration time for recorded video. If the set date is overdue, the
recorded data will be deleted automatically.
7.2 Encode Parameters Setting
Click Start
à
Settings
à
Record
à
Encode Parameters to go to the interface as shown below. Set
the video encode, resolution, FPS, bitrate and audio of main stream for each camera in “Event
Record Stream” and “Timing Record Stream” interfaces. Click “Apply” to save the settings.
You can set the record stream of each camera one by one or batch set them for all cameras.
