Transcendent NVR Series
63
click
to set the camera as the trigger camera. Select trigger camera on the right side and
then click
to cancel the trigger camera. Click “OK” button to save the settings. The
trigger cameras will record automatically when the sensor alarm is triggered.
Snap
: check it and then the “Trigger Snapshot” window will pop up automatically. Configure
the trigger camera in the window. The trigger cameras will snap automatically when the sensor
alarm is triggered.
Alarm-out
: check it and then the “Trigger Alarm-out” window will pop up automatically.
Configure the trigger alarm-out in the window. The system will trigger the alarm-out
automatically when the sensor alarm is triggered. You need to set the delay time and the
schedule of the alarm outputs. See 9.4.1 Alarm-out for details.
Preset
: check it and then the “Trigger Preset” window will pop up automatically. Configure the
trigger preset of each camera. To add presets, please see 6.2 Preset Setting for details.
Buzzer
: if enabled, the system will begin to buzz when the sensor alarm is triggered. To set the
delay time of the buzzer, please see 9.4.4 Buzzer for details.
Pop-up Video
: After camera setting, the system will pop up the corresponding video
automatically when the sensor alarm is triggered. To set the duration time of the video, please
see 9.4.3 Display for details.
Pop-up Message Box
: if enabled, the system will pop up the corresponding alarm message box
automatically when the sensor alarm is triggered. To set the duration time of the message box,
please see 9.4.3 Display for details.
E-mail:
if enabled, the system will send an e-mail when the sensor alarm is triggered. Before
you enable the email, please configure the recipient’s e-mail address first (see 11.1.4 E-mail
Configuration for details).
9.2 Motion Alarm
Motion Alarm
: when the motion object appears in the specified area, it will trigger the alarm.
You should enable the motion of each camera first and then set the alarm handling of the
camera to complete the whole configuration of the motion alarm.
9.2.1 Motion Configuration
�
Click Start
à
Settings
à
Camera
à
Motion to go to the following interface.
Transcendent NVR Series
64
�
Select the camera, enable the motion and set the sensitivity and duration of the camera.
Sensitivity
: the higher the value is, the more sensitive it is to motion. You should adjust the
value according to the practical conditions since the sensitivity is influenced by color and time
(day or night).
Duration
: it refers to the interval time between the adjacent motion detections. For instance, if
the duration time is set to 10 seconds, once the system detects motion, it will go into alarm and
would not detect any other motion (specific to camera) for 10 seconds. If there is another
motion detected during this period, it will be considered as continuous movement; otherwise it
will be considered as a single motion.
�
Drag the camera image to set the motion area. You can set more than one motion area.
Click “All” to set the whole camera image as the motion area. Click “Reverse” to swap the
motion area and the non-motion area. Click “Clear” to clear all the motion areas.
�
Click “Apply” to save the settings. Click “Processing Mode” to go to the alarm handling
configuration interface of the motion alarm.
9.2.2 Motion Alarm Handling Configuration
�
Click Start
à
Settings
à
Alarm
à
Motion Alarm to go to the following interface.
