Summit & Summit 800
Feature Description and Operation Manual
Issue 1.2
82
Conditions
1. The
[CONF]
button remains illuminated at the initiators phone for the duration of the
conference.
2. If the system receives a disconnect signal and no internal parties remain in the
conference, the conference is terminated and all parties are disconnected. If an
internal party is still connected when a disconnect signal is received, the connection to
remaining parties is maintained.
3. The normal Hold Recall process is applied to a conference on hold using the
Unsupervised Conference recall Timer for recall timing.
4. If while setting up a conference, system error tone is received, the initiator must press
the
[CONF]
button to regain Intercom dial tone; an SLT user must hook-flash.
5. A station that is busy, in DND or other non-idle state cannot be added to a conference.
6. A SLT user can establish a 3-party conference only, but can be a member of other
multi-party conferences.
Programming
Related Features
Automatic Speaker Select
Hold Recall
Unsupervised Conference
Broker Call
Conference Room
Hardware
2.22.5 Unsupervised Conference
Description
Using your iPECS IP or LDP Phone, you may establish a conference with external parties and
exit the conference while allowing the external parties to converse privately without the system
supervising the connection through your phone. In this case, the system monitors the outside
Lines to determine if either party disconnects. Also, the Unsupervised Conference timer is
initiated when an Unsupervised Conference is established. Fifteen seconds prior to expiration of
the timer, a Warning Tone is provided and at expiration, the call disconnects.
If enabled, either party in an Unsupervised Conference can extend the Unsupervised Conference
beyond the timer expiration. The party enters the Timer Extension feature code and a digit “1” to
“9” indicating the Timer extension multiplier. The system extends the timer based on the dialed
digit multiple of the Timer. For example, if the Unsupervised Conference timer is 5 minutes and
the user dials the digit 4, the timer will extend to 20 minutes (4 multiplied by 5 minutes).
