Chapter 2 — Decoder Command Set Guide
113
SCSI Command Error Conditions
BUSY SCSI Status may be returned if decoder has not entirely finished executing
the last decoder command. (Retry command.)
When genlock is enabled [via
DECODER
(45h) command, command code 0016h],
and the genlock request is not present (bit 15 of command = 0):
Additional Sense Bytes (bytes 18 & 19) will be set to 0107h. The MPEG PLAY
command in this genlock mode is not executed.
When “Soft Error Mode” and genlock is not present at Play command, the follow-
ing error is returned (bit 15 of command = 1): “Recovered error, genlock sync lost.”
WRITE BUFFER
“Illegal request, invalid field within CDB.” A reserved or specific field contains
invalid data.
“Illegal request, logical block address out of range.” Address or transfer length is
outside the range of the microcode memory.
SCSI Status
Check Condition
Sense Key
05h
Additional Sense Code and Qualifier
6100h
SCSI Status
Check Condition
Sense Key
01H
Additional Sense Code and Qualifier
6100h
Additional Sense Bytes 18 & 19
0107h
SCSI Status
Check Condition
Sense Key
5h
Additional Sense Code and Qualifier
2400h
SCSI Status
Check Condition
Sense Key
5h
Additional Sense Code and Qualifier
2100h
Summary of Contents for 2000-0600
Page 10: ......
Page 49: ...Chapter 1 Getting Started 39 Customer Support Figure 1 23 CineCast HD Rear Panel View...
Page 52: ......