12
CineCast HD Version 2.6 Installation and User Manual
Decoder Installation
Bus Termination
A terminator switch is located on the rear of the decoder board. Setting the switch
to the left position (farthest away from the connector area) enables termination.
Model HD/2 decoders should have termination enabled on only one of the two
boards contained within the unit, per general SCSI procedures.
Host Adapter (Initiator) Configuration
The following Ultra-2 SCSI host adapters, based on the PCI bus, are recommended:
• Qlogic™ Ultra-2 Wide SCSI host adapter, model QLA-1080.
• Adaptec™ 29160 Ultra 160 host adapter.
Host Adapter Parameter
Setting
Disconnect Allowed
Enabled (mandatory for multiple SCSI
decoder operation)
Synchronous Data Transfer
(Synchronous Negotiation)
Enabled
Synchronous Data Transfer Rate
80M transfers/second (REQ/ACK period)
Wide Data Transfer (16-bit)
Enabled
Renegotiate on Error
Enabled
Enable Device at Boot
Enabled
Enable LUN
Enabled
Table 1-2. Host Adapter Settings
Parameter
Decoder
SCSI
Supports SCSI Disconnect-Reconnect
SCSI Transfer Rates
•
Asynchronous SCSI supports up to 10MBps for fast/
wide SCSI (16-bit Fast SCSI-2)
•
Synchronous SCSI supports 80MBps for Ultra-2/Wide
SCSI (16-bit Ultra-2 SCSI-2)
Table 1-3. SCSI Parameters
Summary of Contents for 2000-0600
Page 10: ......
Page 49: ...Chapter 1 Getting Started 39 Customer Support Figure 1 23 CineCast HD Rear Panel View...
Page 52: ......