FM +
FM T55
QUICK START GUIDE
Wi-Fi Network Required
If Wi-Fi audio is desired, the FM + connects to the installation
location's Wi-Fi Network. It does not provide a network on its own.
The Wi-Fi network will need to be installed and established before
the FM + can be used.
You may connect the device to a computer via a hardwired
connection to help troubleshoot any networking problems.
A Wi-Fi network is not required for broadcasting audio over FM.
Installation Procedures
1. Position the FM + transmitter near the sound system or mixer
from which it will receive audio. We do not recommend wall or
ceiling mounting, or putting the device on a cart.
2. Connect the power supply to the Power Supply connector
located on the back of the FM +. Press in the power button on
the front of the FM +. The power button should light up. If not,
go back and check the power connections.
3. Choose and configure the audio source.
CAUTION!
This source
must be configured in the menu
before plugging the source into the jack. Voltage sent to the jack
based on the source selected in the menu. Selecting the wrong
configuration could send the wrong voltage to the source and
cause damage.
The audio source must be configured in the menu before
plugging the source into the jack (except Dante Audio - skip
to step 9)
. Push the Menu button and push the right arrow button
once to display AUDIO SOURCE on the screen. Push the right
arrow button to access the audio sources. Using the up or down
arrow buttons, choose between ANALOG LINE IN, MIC, PHANTOM
MIC +12V, 400 Hz Test Tone, or DANTE. When the desired audio
source is displayed, press the right arrow button to apply the
setting. Press the center Menu button to exit the menu.
4. Push the power button to turn the unit off.
5. Connect the audio source to the audio input jack on the rear
of the FM +.
6. Push the power button to turn the unit on.
7. With the audio source playing, adjust the Audio Level on the
FM + so that the green 0 dB LED generally lights and the red
+9 dB LED lights occasionally. To do this, use the Hot Buttons
while on the main info screen. Press the up arrow button to
increase the audio level in 1.0 dB steps, or press the down
arrow button to decrease the audio level in 1.0 dB steps.
8. Select an Audio Preset. The FM + has three pre-configured
Audio Presets to choose from: Hearing Assist, Music, and
Voice. A Custom preset is also available. The performance of
the FM + is optimized for each of the pre-configured Audio
Presets.
Using the menu and control buttons on the front of the FM +,
push the Menu button, the display will change to show Audio
Settings. Use the right arrow button to display Audio Source in
the selection box. Push the down arrow button to show Audio
Presets. Now press the right arrow button to display the list
of Presets. Use the up and down arrow buttons to alternate
between Hearing Assist, Music, Voice and Custom selections.
When the desired Audio Preset is displayed, press the right
arrow button to apply the setting. If Custom is desired, push
the right arrow button to enter the custom settings. Press the
Menu button to exit the menu.
0.75A
Streaming Audio Out
Ethernet
RoHS
Made in USA
Analog
Audio
Line Out
Line / Mic In
phantom
bal
unbal
24VDC
RF75Ω Ant
Back Panel Diagram
© 2022, Williams AV, LLC MAN 246D
FM
+
– 18
– 15
– 12
– 9
– 6
– 3
0 dB
+ 3
+ 6
+ 9
