14
Revision 01 - 22.07.2019
You can also connect several sensors in turn, while the add window is open, in this case, after
clicking the "OK" button, the sensors will be put into free fields in the order in which they were connected.
After connecting all temperature sensors, you can click the
“Get settings”
button and make the
necessary settings related to temperature sensors, for example, configure sending data from the sensors to
the server in the
“Data transmission”
tab or set the device behavior in the
“Scenarios”
tab.
AUTHORIZED DALLAS KEYS
Vega MT X CAN monitoring device allows you to connect an I-Button authorized key reader to a 1-
Wire pin. The connection scheme is shown in the figure below. The number of authorized keys can reach
ten. To add a key, you need to connect to the device through the "Configurator" program and go to the
"Security" tab (see "Settings" part).
In the "Security" tab, expand the "Authorized Dallas keys" settings item and click the "Add Dallas keys"
button. A dialog box will appear.
Attach the key to the reader as during authorization - the device will remember the key number - and
click "OK". The key number appears in the free field. If several keys are added at the same time, it is allowed
to attach them to the reader in turn, while the add w
indow is open, and only then click “OK”
- the numbers
of all keys will be added to the free fields in the order in which they were applied to the reader.
FUEL LEVEL SENSORS
The monitoring device allows you to connect fuel level sensors via the RS-485 bus and operates with
them using the LLS protocol. To do this, you need to connect to the device
through the “Configurator”
program and go to the “Settings” section
to
the “Inputs/Outputs” tab (see “Settings”
part). For each
connected fuel level sensor, it is n
ecessary to select “Sensor Type”
- RS-485 or RS-232 and specify the