11
Revision 01 - 22.07.2019
SIM INSTALLING
To use the Vega MT X CAN monitoring device, you need a micro-SIM with support of SMS and GPRS
functions. There must be cash on the account. PIN protection must be disabled.
The device supports the ability to use two SIM cards. In this case, one of them will perform the
reserve function, and will be used only if it is not possible to send data from the first main SIM. The location
of the primary and secondary SIM slots is shown in the figure below, the primary slot is highlighted in red.
To install the SIM, you must remove the top cover of the device. Then insert the SIM into the holder
and assemble the device.
INITIAL CONFIGURATION
Initial configuration is carried out through USB-port with Configurator application. For this you
should follow the next steps:
1.
Connect the connector with wires to the device.
2.
Connect an external power with voltage of 7-36 V (
See “Contacts description” part
). After power
connection the red LED will must become glowing.
3.
Connect the device to the PC through USB-port located on the front panel.
SIM