34
Revision 01 - 22.07.2019
To reduce the amount of incoming information, you can configure filters by clicking the settings
button "
" next to the start button.
Here you can set one mask for each of the three CAN buses. If masks are not set, then all data from
all
buses will be displayed, regardless of the filters previously configured in the “
CAN hardware s
ettings” of
the “CAN
-s
ensors” tab
.
Next is a drop-
down menu for setting the bus read mode. If the “Monitor” mode is selected, the
information will be displayed i
n the form of frames that are constant but change their values. If the “Stream”