20
Assembling
Wire
1.
Wiring from the front side to the rear side
[1]
Remove the six screws (cap screw M3 × 6) retaining the cover of the
rear tension unit (Home side), and then detach the cover.
[2]
Put the take-up sensor cable (label: J9) and take-up switch cable
(label: J2) through the front side to the rear side.
• A: Untie the cable, and then put it through under the rail.
• B: Put the cable through two clamps on the path.
• C: Put the cable through the grommet.
Note
The take-up sensor cable is the cable that is coming out of the front tension unit (Home
side).
• When you want to put the cable through under the rail in the illustration A
above, make sure that it looks like the left illustration.
[3]
Connect the take-up sensor cable (label: J9) to the controller board.
• A: Put the cable around the clamp once.
• B: Connect the cable connector to the connector [J9] on the controller
board.
Note
This illustration only shows the cables that need to be connected in this step and others
are omitted. Other illustrations also follow the same rule.
A
B
C
wv
u
B
A
Summary of Contents for MUTOH VJ-1938TX
Page 55: ......
Page 56: ...VJ1938TXE Q 04...